![]() The automation is equipped with an anti-crush safety system that is a torque control device which guarantees the utmost safety and reliability if properly adjusted. The installer must supply all information regarding manual operation of the system in the event of an electrical failure or other emergency. Use only SAIMATIC original spare parts for maintenance operations. ![]() The end-user must avoid any attempt to repair or adjust the automation personally these operations must be carried out exclusively by qualified personnel. The yellow / green wire of each operator MUST be connected to a good electrical ground point. Before carrying out any cleaning or maintenance operations, switch off electrical power supply and / or unplug the power connector from the controller circuit board. The suppliers cannot be held responsible for damage or injury caused by improper, incorrect, or unreasonable use. Any other use should be considered improper and therefore dangerous. This equipment should be used only for the purpose for which it has been designed and intended for. Before installing the gate automation system, make all necessary structural modifications to ensure that any cutting, entrapment, or crushing areas are mechanically or electronically protected. Distributors and dealers of SAIMATIC products cannot be held responsible for damages or injuries caused by improper installation of gates or gate automation systems. Installation, electrical wiring, and adjustments must be carried out in compliance with current safety standards. Keep these instructions for future reference. ![]() 1 Saimatic Aster Gate Operator, Automation System Manual 12/24Volt CTR 50ΔΆ WARNINGS AND PRECAUTIONS Read the instructions carefully before installing the gate automation system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |